Remember to share the password you have created with only those authorized to configure the network. ISTANBUL(config)#enable password cisco123 You can use the enable password “password” command to set a password for the Cisco Router. You must set the Enable password to restrict or prevent unauthorized access to your router.Įnable Password sets a password when you switch to the Privileged Execute Mode at the router’s CLI command prompt. ISTANBUL(config)#interface fastethernet 0/0 If you want to close the interface, you should only use the shutdown command. No shutdown command opens the closed interface. Then use the no shutdown command to make the port available. In short, you can use the ip address (address) (subnet mask) command in config mode of the interface you configure. It is simple and easy to assign an IP address to the Interfaces of your Cisco network devices and turn on the corresponding port. Step 2: Assigning an IP Address to the Router’s Interface To do this, you can use the Hostname command in your device’s config mode. You can change the name of your router for the first step.
Basic Cisco Commandsįollow the steps below to configure Cisco Router. In addition, you can use SDM to configure a Router for the first time. However, instead of using an automatic setup wizard, it is more convenient to configure your device with the CLI command prompt. You can also configure your device as a base with this automatic installation. If you are running the Cisco Router for the first time, you will be presented with an automatic setup screen.
0 kommentar(er)
